
S-197 - 2 Piece Replacement Rotors
Front
This is the weight of the 14" front OEM rotor
S-197 14" Street/Strip version
FT 9108
This is our latest design in reduced weight and improved looks, 2 pc front rotors for 2007-2011 GT500's and 2011 Mustang GT's with 14" Brembo brake package. These rotors have Hardcoated aluminum hats with plated grade 8 attaching hardware. The rotors are directionally vaned, slotted, stress relieved and clear zinc plated for a nice lasting appearance.
The weight savings are as follows:
Front OEM rotors weigh 25.32
lbs each. Our rotor weighs 19.8 lbs for a weight savings of 5.52 lbs
each and a total front weight savings of 11.04 lbs for the pair. This is
a typical weight savings you find in a moderately priced pair of lightweight
wheels that cost about what these rotors cost. So with the addition of a
pair of lightweight wheels you could easily remove 20 lbs of unsprung parasitic
rotating mass off of the heavy front end of a GT500 and possibly as much as 30
lbs if you put on a much lighter and higher priced wheel.
These front rotors are recommended only for street and
strip duty.
S-197 Street / Strip Front rotor pair sells for $675.00 plus freight.
FT 9108
Replacement rotor rings are Stress Relieved, Slotted and Clear Zinc Plated; $213.50 each.
S-197 14" Heavy Duty/Road Race version
FT 9108 HD
We've finally received our newest
addition to our rotor line. The heavy duty road race version of our S-197 14"
front 2pc rotors.
These rotors are actually heavier walled than the OEM
Brembos. The braking faces on these new rotors average .367" thick with a center
air gap of .515". The Brembos have average braking face thickness of .335" and
air gap of .585". Our rotors are directionally vaned and will pump more cooling
air than the non-directional OEM Brembos.
Here is a photo of the front
of the rotor showing the rotor weight of 23.88# a 1.44# weight savings over the
25.32# OEM Brembo. Total weight savings for two rotors would be 2.88#.
|
|
| S-197 14" Heavy Duty Road Race Pair | Backside of rotor assembly |
Here is a thickness and air gap side by side comparison of the OEM brembo and the FTBR road race HD version
The Heavy Duty / Road Race Front rotor pair sells for $675.00 plus freight.
FT 9108 HD
Replacement rotor rings are Stress Relieved, Slotted and Clear Zinc Plated; $213.50 each.
We also offer S-197 Front Brake Cooling Ducts
Rear
This is the weight of the Rear OEM rotor
The rear OEM rotor weighs 13 lbs each. Our rotors weigh 10.56 lbs for a weight savings of 2.44 lbs each and a total rear weight savings of 4.88 lbs for the pair.
Rear rotor pair sells for $595.00 plus freight.
FT 9109
Replacement rotor rings are as follows:
11.8" Rear Rings: Slotted and Clear Zinc Plated; $115.00 each.
Rotors mounted on car:
We also offer a tool for compressing fixed front caliper pistons.
WARRANTY AND DISCLAIMER: FULL TILT BOOGIE RACING, INC., A WISCONSIN CORPORATION (“SELLER”), HEREBY WARRANTS THAT THE ENCLOSED AUTOMOTIVE COMPONENTS ARE FREE FROM DEFECTS IN WORKMANSHIP AT THE TIME OF SHIPMENT, BUT DISCLAIMS AND EXCLUDES ANY AND ALL OTHER EXPRESSED OR IMPLIED WARRANTIES REGARDING THE ENCLOSED AUTOMOTIVE COMPONENTS. PURSUANT TO THE UNIFORM COMMERCIAL CODE, ARTICLE 2, SECTION 316, SELLER SPECIFICALLY EXCLUDES ALL WARRANTIES OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR PURPOSE. SELLER DIRECTS PURCHASER TO FULLY INSPECT AND EXAMINE EACH ENCLOSED AUTOMOTIVE COMPONENT BEFORE INSTALLATION AND TO USE EACH AUTOMOTIVE COMPONENT AT PURCHASER’S OWN RISK. IN THE EVENT THAT ANY AUTOMOTIVE COMPONENT IS DEFECTIVE UPON PURCHASER’S RECEIPT, PURCHASER’S SOLE REMEDY SHALL BE TO RETURN THE DEFECTIVE AND UNUSED AUTOMOTIVE COMPONENT TO SELLER WITHIN FIFTEEN (15) DAYS AFTER PURCHASER’S RECEIPT AND REQUEST IN WRITING EITHER A FULL REFUND OR A REPLACEMENT, WHICH SELLER SHALL SHIP TO PURCHASER AT NO ADDITIONAL CHARGE.
Full Tilt Boogie Racing Inc........1817 Dolphin Drive.......Waukesha, WI 53186.........info@fulltiltboogieracing.com